step » validate(prompt,responses,passResponses)

Description

This command provides manual validation. Nexial will pause the current execution and display a prompt on the console, from which can provide the appropriate response as validation. The responses parameter is a comma-separated list of possible responses, and passResponses parameter presents a list of comma-separated responses that will be considered as PASS. If user provides a response that match one of the passResponses, then the corresponding test step is considered as PASS. Otherwise, Nexial will consider the corresponding step as FAIL.

The screenshot below is an example that shows the prompt and a set of possible responses:

Parameters

• prompt - The prompt to the intended validation
• responses - Comma-separated list of possible responses
• passResponses - Comma-separated list of “PASS” responses. Note that these responses must be found in responses as well. If user’s response does not match one of these passResponses, the command is considered as FAIL

Example

Script:

Output:

See Also

• perform(instructions)
• observe(prompt)